(2) Gb Over IP Interconnection Guideline

  • Published on
    29-Nov-2014

  • View
    108

  • Download
    3

Embed Size (px)

Transcript

Gb over IP interconnection guideline1 The difference between static configuration and dynamic configurationThere are only two differences between static configuration and dynamic configuration:(1) When configure the NSE, we need to configure the server IP address and server UDP port number only for dynamic configuration. (2) Remote NSVL need to be configured only for static configuration.

2 The network structure

3 configuration steps(1) Configure NSEBSC6000Configure PCU Data Configure NSE

2011-9-7

1 , 6

We dont need to configure this part when it is static configuration

(2) Configure the port IPBoard GFGUG Configure Ethernet Port IP

Port IP

(3) configure device IP Board GFGUG Configure Device IP

2011-9-7

2 , 6

Device IP

(4) Configure BSC router

Board GFGUG Configure BSC Router

The router to the logic IP of SGSN, it should be a network section

(4) configure local NSVL

Board GFGUG Configure BSC Router

2011-9-7

3 , 6

IP address: port IP UDP port No.: any number larger than 1024 is OK.

(5) Configure remote NSVL BSC6000Configure PCU Data Configure Remote NSVL

The same with local NSVL of SGSN.

(6) activate the port

Board GFGUG Configure Board Attributes

2011-9-7

4 , 6

(7) configure PTPBVC BSC6000Configure PCU Data Configure PTPBVC

2011-9-7

5 , 6

4 Maintenance (MML)1Ping IP After you finish configuration, use MML to check the whether the physical link between BSC and SGSN is OK.

2DSP REMOTENSVL For dynamic configuration, this command is to check whether the remote NSVL is ok.

3DSP GBIPROUTE This command is to IP router which shows the status of NS.

4DSP SIGBVCDSP PTPBVC The normal status of SIGBVC and PTPBVC should be unblocked.

2011-9-7

6 , 6